4. PORT FORWARDING 1ST ROUTER TO 2ND, LAN TO WAN:
In this situation, the existing router/network is left intact and the Elan router is added as a separate network.
The WAN Port of the 2
nd
router is set to a static IP on the 1
st
router, and the 1
st
router is configured to forward
ports to the 2
nd
router. The 2
nd
router can then perform the correct port forwarding to the Elan Controller. In
this install, it is assumed that the two routers are each on their own subnet, i.e. Router/Modem IP is
192.168.1.1, D-Link/Router 2 is set to 192.168.0.1.You will need configuration notes from a manual, the ISP,
or the internet for the router to accomplish this. To make/verify these changes, you will need to have a Cat-5
cable going from your computer directly into one of the LAN ports on the routers.
Note: If you cannot find out how to forward ports, or Port Forwarding isn’t supported or working, you may be
able to place the 2
nd
router into the 1
st
routers DMZ as an alternative. See Option 5 below for details.
5. PLACE THE 2
ND
ROUTER IN THE 1
ST
ROUTERS DMZ:
Sometimes port forwarding is not possible with an ISP provided Router/Modem, and it may be possible to
place the 2
nd
router in the 1
st
routers DMZ. In this situation, the existing router/network is left intact and the
Elan router is added as a separate network. The WAN Port of the 2
nd
router is set to a static IP on the 1
st
router, and the 1
st
router is configured with the 2
nd
Router in its DMZ. The 2
nd
router can then perform the
correct port forwarding to the Elan Controller. In this install, it is assumed that the two routers are each on
their own subnet, i.e. Router/Modem IP is 192.168.1.1, D-Link/Router 2 is set to 192.168.0.1. You will need
configuration notes from a manual, the ISP, or the internet for the router to accomplish this. To make/verify
these changes, you will need to have a Cat-5 cable going from your computer directly into one of the LAN
ports on the routers.
A Note on DMZ (D
eMilitarized Zone):
Placing a device in the DMZ effectively removes all protection from it. Placing the 2
nd
router in the 1
st
router’s
DMZ is acceptable because devices behind the 2
nd
router will still be protected by the 2
nd
router.
**NEVER place the g! Controller directly into a DMZ as it will be unprotected. **
Wiring Diagram (Options 4&5):
Wiring Configuration (Options 4&5):
Leave existing connections on the 1
st
router as is, and run an additional CAT-5 from a LAN port on the 1
st
router to the WAN port on the Elan (D-Link) router. Connect all other network devices that are to be used with
Elan to LAN ports on the 2nd router.
www.elanhomesystems.com/dealer Tech Support: 800-622-3526
Page 8 of 11
(2 pagine)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale